Ciao a tutti. Ho una domanda tecnica sulla mia manopola Heizung che ho rotto accidentalmente (onestamente era appesa a un filo). Comunque voglio evitare di perdere una grossa parte della mia Kaution, come ben sapete potrebbero dire che è una manopola rara e costa migliaia di dollari ecc. dove posso trovarla e posso installarla personalmente o ha bisogno di un intervento professionale. Se sì, quanto costa in realtà? Grazie mille.
https://i.redd.it/3uwbt5o5z0md1.jpeg
di Ok_Double_1993
5 Comments
Take the thermostat to the nearest large DIY store, where you should be able to get a suitable replacement. If it’s nothing completely exotic, the part costs between €10 and €30 and can be screwed on in 2 minutes.
To be on the safe side, measure the diameter of the thread on the pipe in case the thread on the thermostat is completely broken.
I hope you didn’t break off the metal pin inside of there. If so you need to replace the whole valve (the gray unpainted part) which is very complicated and can only be done by shutting of the whole heating loop and draining part of it.
Check if you can screw out the black plastic. If the metal pin is sticking out you are fine and can just replace the knob. If not it’ll become very expensive. And I would really discourage you from doing that yourself since so much can go wrong.
Standard part. Just replace. It’s not necessary to drain the heating loop.
IM CALLING THE POLICE
Buy a neuer one. Schmeiß weg den old one. Install the neuer. It’s einfach. Gogol hilft bei instruction searching für Installationsprozess.