Hey, I would take the door of the hinges. ( just lift it up) Then gently pullout the loose part. Get wood dowels and glue them in the holes. After they are set, drill two new holes slightly smaller than the hinge bolts. Hammer them in the holes together with some wood glue. Iam not a professional but that’s how I would approach the problem without replacing anything major.✌🏼🫶🏻
Hope this helps.
ArmMammoth2458 on
If it was me, I would just cheap out and use some type of glue or epoxy but there might be a better way
ChuckCarmichael on
According to [this post on r/Handwerker](https://www.reddit.com/r/Handwerker/comments/18vu6pb/t%C3%BCrscharnier_rutscht_aus_t%C3%BCrrahmen/), the small plate that reads Wirus is actually a thing you can take off. There’s a screw behind it that determines how tightly the hinge sticks inside the wood. So take off the door, push the hinge back in, pop off the plate, tighten the screw, put the door back on, then tighten the screw again.
3 Comments
Hey, I would take the door of the hinges. ( just lift it up) Then gently pullout the loose part. Get wood dowels and glue them in the holes. After they are set, drill two new holes slightly smaller than the hinge bolts. Hammer them in the holes together with some wood glue. Iam not a professional but that’s how I would approach the problem without replacing anything major.✌🏼🫶🏻
Hope this helps.
If it was me, I would just cheap out and use some type of glue or epoxy but there might be a better way
According to [this post on r/Handwerker](https://www.reddit.com/r/Handwerker/comments/18vu6pb/t%C3%BCrscharnier_rutscht_aus_t%C3%BCrrahmen/), the small plate that reads Wirus is actually a thing you can take off. There’s a screw behind it that determines how tightly the hinge sticks inside the wood. So take off the door, push the hinge back in, pop off the plate, tighten the screw, put the door back on, then tighten the screw again.